Quick-Change Mini Flap Discs: Match TR vs. TS Before Buying

Illustration of loose abrasive flap discs and a separate backing pad on a steel workbench.

If a replacement mini flap disc is the right diameter and grit but won’t match the pad, check the attachment before you order again. In Norton’s BlueFire R860 mini flap disc line, TR means Type III and TS means Type II. The same size and grit can come in either attachment. Match the disc and pad by the manufacturer’s markings or part numbers, not by how similar the discs look from the abrasive side.

The hero is an illustration, not a product photo or an attachment-identification diagram.

The same 2-inch, 40-grit disc can have two part numbers

Norton’s mini flap disc flyer gives a useful example. For the 2-inch, 40-grit BlueFire R860, Norton lists 77696090166 for TR (Type III) and 77696090176 for TS (Type II). Both rows belong to the same abrasive family. The attachment choice changes the number you order.

  • Pad identified as Norton TR/Type III: The 90166 example belongs to that attachment family. Still confirm the pad size, tool and ratings for your setup.
  • Pad identified as Norton TS/Type II: The same-size TS example is 90176, not 90166. The TS number here is a manufacturer reference, not an Arc Weld stock claim.
  • Pad is unmarked or from another brand: Look up its model or get the manufacturer’s confirmation before assuming its attachment works with either disc. A quick-change label by itself doesn’t settle the match.

Start with the backing pad, not the cart

If the old disc or carton is still around, record its full item number and take photos of both sides. Then identify the pad you plan to keep. Include its markings and a photo of the disc-side attachment. A picture of the outside diameter alone won’t show which system you have. If the original disc and pad were from different setups, keep their photos separate so the supplier can tell which part you actually use.

Use the pad maker’s information to verify its intended disc diameter and attachment. Separately check the actual tool manual and the accessory markings for the approved setup and applicable speed limits. A maximum speed printed for one component should not be copied to another component. Follow the tool and abrasive manufacturers’ instructions for guarding, inspection and protective equipment. If the pad is worn or you cannot establish the match, stop and verify the parts instead of forcing the disc onto it.

Check how many discs are in the listing

Norton’s flyer shows a standard package of ten for the 2-inch, 40-grit TR number. That is not the quantity shown for every seller’s offer. Arc Weld’s Norton 90166 listing is labeled three pieces. If you are replacing a known 2-inch, 40-grit TR/Type III setup, that is the exact Arc Weld listing to compare. Use its selling unit when working out how many discs to order; don’t multiply the cart quantity by the manufacturer’s ten-piece standard package.

Put five details on the reorder note

  1. Backing-pad make and part number, with the attachment identified.
  2. Exact disc series and part number.
  3. Disc diameter and grit.
  4. Confirmed tool and accessory setup, including applicable limits.
  5. Pieces per selling unit and total pieces you need.

That note gives the next person enough to buy the same part instead of starting over with “the blue two-inch ones.” If the pad or grinder changes, recheck the setup before reusing the old order number.

Back to blog